Adding Nets

<< Click to Display Table of Contents >>

Navigation:  The PCB > Nets >

Adding Nets

To add a net to a PCB:

1.Click on the AddAdd Net button in the menu.

2.Move the mouse so it is over a pad, via or track and the cursor will turn to a green tick.

3.Left-click when you see the green tick to start a net.

4.Now move the mouse. As you move it a yellow line will be drawn from the source pad, via or track.

5.When the cursor goes over a valid end point for the net, the cursor will turn into a  green tick.

6.Left-click when you see the cursor turn to green tick. The net will then optimize itself.