Adding Point Guides

<< Click to Display Table of Contents >>

Navigation:  Drawing Aids > Guides > Point Guides >

Adding Point Guides

There are 2 ways to add a point guide to a sheet.

1.The first and easiest is to hold down the left mouse button on the ruler origin in the upper left hand corner of the rulers (If rulers are visible) and drag it into position.

2.The second method is to click on the clip0123 button in the AddGuides button group.

3.

clip0125

The point guide and its X,Y position during initial creation

In both cases, as you drag the guide to position it you can enter a number value by first pressing the Enter key and then the X and Y coordinate or click the left mouse button to place the guide.

You can press the 's' key at any time to turn snap on or off.