Adding Tooling Holes

<< Click to Display Table of Contents >>

Navigation:  The PCB > Panelised PCBs >

Adding Tooling Holes

Tooling holes, while not as relevant as they used to be, are still valuable to have and do not usually cost any extra to add. You can put 4 of them in the corners and they are 3.175mm in diameter (which is 1/8" which was a standard pin support size that most of the industry standardized on in the 80's)

 

You can add 4 tooling holes 1/8" in diameter to the 4 corners of the panel

clip1352

Check Add Tooling Holes to automatically add 4 tooling holes.

clip1364