Antenna Parts

<< Click to Display Table of Contents >>

Navigation:  Parts > Parametric Parts > Type Selection > The Part Builder >

Antenna Parts

You can create a coil pattern on a copper layer to act as a antenna coil.

To create an antenna part click the clip0667 button in the The Part Builder

The part builder will automatically create the copper pattern and pads for the device and also a suitable schematic symbol with the pin names left blank for you to fill in.

clip0723

Schematic Symbol without outer ring

clip0731
clip0722

Copper pattern and pads

clip0721

3D View of the antenna

 

Device Overview

Inductor Parameters

Pads

Package Color

Package Reference

Package Value

Package Silkscreen

Package Courtyard

Package Placement Point

Package Symbols