Antenna Parameters

<< Click to Display Table of Contents >>

Navigation:  Parts > Parametric Parts > Type Selection > Arial >

Antenna Parameters

clip0700

Antenna Parameters

clip0724

Inner Radius. The inner radius. See the diagram above.

Track Width. The width of the copper track forming the antenna.

Trace Space. The space between copper rings. See the diagram above.

Rings. The number of complete rings.

Check the clip0730 checkbox to use plated through holes for the pads. Uncheck to use SMT pads,

Check the clip0725 checkbox is run the rings clockwise. Uncheck to run the rings in the opposite direction.

clip0727

Clockwise

clip0726

Anticlockwise

Check the clip0729 checkbox to add an outer ring.

clip0728

Antenna with outer ring