Border

<< Click to Display Table of Contents >>

Navigation:  Parts > Creating Parts > Symbols >

Border

Symbols optionally have a terminal magnet. Terminal magnets server as anchor edges forces all symbol terminals to stick to the edge. Terminals cannot be dragged of the edge. As you drag a terminal the terminal will try to follow but it will always remain attached to the border.

Terminals always stick to a grid of 0.1 units. This gives you a good separation of terminals. Schematic wires snap to a 0.05 unit grid.

You can delete the border by selecting it and pressing the DEL key.

clip1121

A terminal magnet with no terminals

clip1122

A terminal magnet with terminals

clip1123

Organized by pin name

clip1124

Organized by name with grouping

clip1125

Pins on all 4 sides

clip1126

Pins on left

clip1127

Pins on right