Editing Arcs

<< Click to Display Table of Contents >>

Navigation:  Graphics > Arcs >

Editing Arcs

To edit an arc first select it.

clip0264

Drag either of the arc's end manipulators( clip0265 ) to change the start/end angle of the arc.

Drag the arc's diameter manipulators( clip0265 ) to change the diameter of the arc

Drag any rotate manipulator clip0266to rotate the arc.

Drag any scale manipulatorclip0267 to re-size the arc.

Drag the arc to move it.

Arc Properties Dialog

You can also edit the parameters of the arc using its properties panel as shown below. To view the properties panel first select it.Then right-click on it, then select Properties Panel from the context menu that opens.

clip0268

Click the clip0523 button to show this help topic.

Center

Enter the X and Y coordinates for the center of the arc.

Radius

Enter the X and Y radius for the arc.

Start and End Angle

Enter the start and end angle for the arc in degrees.

Click clip0269to swap the start and end angles.

Use the Layers drop down to change the layer of the arc.