MELF

<< Click to Display Table of Contents >>

Navigation:  Parts > Parametric Parts > Type Selection >

MELF

clip2543 Metal electrode leadless face (MELF) is a type of leadless cylindrical electronic surface mount device that is metallized at its ends. MELF devices are usually diodes and resistors.

Because of their cylindrical shape and small size, in some cases these components can easily roll off the workbench or circuit board before they have been soldered into place. As such, there is a joke which suggests an alternate meaning for the acronym: Most End Up Lying on the Floor. Additionally, MELF components are sometimes called a "roll away" package.

During automated SMT pick-and-place, this happens mostly if the mechanical pressure of the SMD placer nozzle is too low. If the MELF components are placed into the solder paste with enough pressure, then this problem can be minimized. Care must be taken with glass diodes which are less mechanically robust than resistors and other MELF components.

Also, when building up PCBs via manual assembly using tweezers (e.g., for prototyping) then the pressure at the end of tweezers can often cause a MELF component to slip and shoot out the ends, thereby making their placement more difficult, compared to other flat component packages.

Another reason for the nickname of MELF components is that most production engineers do not like to use MELF nozzles on a SMT pick-and-place machine. For them it is waste of time to change from flat nozzles to MELF nozzles. For MICRO-MELF and MINI-MELF most SMD placers are able to use flat chip nozzles if the vacuum is high enough; i.e., higher than for flat chip components. For MELFs with the case size of 0207 or less, it is recommended to use the original MELF nozzle supplied with the SMT machine. Each supplier of such SMD pick-and-place machines offers these types of nozzles.

In order to overcome some of the difficulties encountered when mounting these devices, there are also variants with square electrodes (e.g. SQ MELF, QuadroMELF and B-MELF). These variants are mainly used in semiconductor diodes for applications where the high-reliability of hermetically sealed voidless-glass packages is required.

These handling difficulties prompted development of alternative SMT packages for common MELF components (like diodes) where the power handling capability needed to be similar to MELF components (superior to low-power 0805/0603, etc. SMT components) but with improved automated pick-and-place handling characteristics. This resulted in various squared-off packages with fold-over contacts, similar to rectangular inductor/tantalum capacitor packages

clip2525

 

clip2526

Standard MELF on PCB with Solder

 

clip2527

MELF Parameter Editor

Type

clip2528

Selects one of 3 different package types.

clip2529

Standard

clip2530

Mini

clip2531

Micro

Schematic Symbol

A schematic symbol will be automatically created for you by clicking on one of the following buttons.

clip2532

Symbol Selector

clip2533 IEEE Resistor

clip2539

clip2534 IEC Resistor

clip2540

clip2535 Diode

clip2541

clip2536 Terminal Magnet with 2 Terminals

clip2542

clip2537 Custom with 2 Terminals

clip2538