Style Guide

<< Click to Display Table of Contents >>

Navigation:  Schematics > Wiring Parts Together >

Style Guide

Use Jumpers for wire crossings.

Avoid wire crossings. You often can do this by moving and/or rotating parts. (TP1 can be moved)

Align parts. e.g. V1, R1,R2 and C1, horizontally, R1 and R2 vertically.

Use common point to make circuit function obvious and also pleasing to the eye.

Center the schematic on the page.

Show signal flow from left to right. Inputs on the left, outputs on the right.

However, as always with AutoTRAX, the choice is yours.

clip0809

Good

clip0811

Ugly and ambiguous (jumper)